by Nuts » Thu 17 Feb, 2011 1:23 pm
Tying to where, do you have the new one with the mid height tie outs?
Id suggest clip on (nite-eze biners) or something, you will very rarely need extra guys and you wont want them hanging loose when you dont/cant use them. And they did put them in a rather odd place... After many years they have finally added the tie outs, i suspect more of a marketing tweek, afterall Hex/SL3 built their reputation well before this model... The tie outs may stop a bit of 'flapping' but its not bad and they should have been Between section ties (ie the lower peg points) to make any real difference.
Some people add a long tie to the top hat point which may hold it up if some pegs pull out. I dont see that as a good idea either... As that would happen on the upwind side, It Would then be holding whats left like a windscock...
The real beauty of a tipi is simplicity...
Otherwise yer, the bowline and those mini sliders are nice.