Another cheap tent rebuild

[Moondog55]

Having a play-around with the hubbed wands I got from Rays closing down sale
I think I can make this work with a bent coupling in the centre
Not sure what angle I'll need yet but it should add a touch more strength, not much but perhaps just enough in combination with another wand on the outside
I withdrew the Megamid pole from sale because I can use it as a reinforcing vertical pole if the weather gets really gnarly, replace the plastic cap with a small stainless eye bolt with a large diameter flexible wand section threaded thru the eye

Attachments

IMG_9546.JPG (112.36 KiB) Viewed 9707 times

IMG_9547.JPG (118.7 KiB) Viewed 9707 times

IMG_9548.JPG (129.76 KiB) Viewed 9707 times

Needs that angle joiner and 2 sections

IMG_9549.JPG (127.44 KiB) Viewed 9707 times

[Moondog55]

I just ordered a 145 degree 9mm angle joiner from ANSCO; expensive but no-one else seems to have 9mm joiners, it it works and that angle is close enough I'll order a second unit for the outside pole

[Moondog55]

It fits
I like Gothic arches and it seems as if 145 was actually the correct angle.

Attachments

IMG_9567.JPG (122.7 KiB) Viewed 9648 times

IMG_9568.JPG (163.51 KiB) Viewed 9648 times

IMG_9569.JPG (150.03 KiB) Viewed 9648 times

[Neo]

Looking good MD.

[Moondog55]

Still looking at all the other options too.
That Rays closing down sale was good value

[Moondog55]

This project on hold until I can afford proper a Easton pole set from TPT or I decide to sell it off cheap